Apply Your Decals Like A Pro

Apply Your Decals Like A Pro

Apply Your Decals Like A Pro

Have you ever turned a perfectly attractive decal into a twisted clump or a wrinkled eyesore? Here are some tips and tricks that will help you apply your decal with ease every time!

Tip 1: Start With A Clean Surface

Pre-wash the area where you’ll be applying the decal using either soap and water or a mixture of rubbing alcohol (70% isopropyl alcohol) and water—we recommend a 50 / 50 water / alcohol solution. After cleaning with soapy water, rinse thoroughly with water until no soap or residue remains. Do not use window-cleaning products. They may leave a residue behind, making your sticker cling less effectively.

Tip 2: Apply When Temperatures Are Moderate

For the best results, install your stickers in a shaded area away from direct sunlight. When possible, you should apply stickers when the temperature is above 50F and below 90F.

Tip 3: Use Masking Tape

Masking tape can help ensure that your sticker is positioned exactly where you want it. Leaving the white backing paper in place and facing the surface you’re applying it to, position the sticker where you want it to go. Place a piece of masking tape along the top edge of the decals this fixes it in the proper location. Then, lift the decals as if it’s on a hinge, and peel off the backing paper. While holding onto the bottom edge, slowly lower the decal, using the thumb of your other hand to press from the center out and gradually working your way from top to bottom.

Tip 4: Use The Wet Method

You can apply most smaller decals without using water, but for large and very large decal, this trick is a life-saver. After cleaning your surface area, wet the area again using a spray bottle and a solution of about 5% soap / 95% water. Apply the decal while the area is still wet. This will keep it from adhering immediately and give you time to reposition if necessary. It also enables you to remove any bubbles using a squeegee or a plastic card. The soapy water will dry in a few minutes and leave your decals firmly affixed.

Tip 5: Tend To The Transfer Tape

Many of our decal come with three layers: 1) transfer tape, the clear top layer that clings to the non-adhesive side of the sticker and holds the sticker together; 2) the decals, the middle layer; 3) backing paper, the bottom layer of white paper that clings to the adhesive side of the decal.

Before applying these types of decal, it’s important to make sure the sticker and transfer tape are pressed firmly together. To do so, apply pressure evenly across the transfer tape with a squeegee or a plastic card. This will ensure that the sticker doesn’t come up with the backing paper during installation.

Also, once you’ve applied your decal, be sure to leave the transfer tape in place for at least 3 hours and up to 24 hours before gently removing it. In very cold winter months, you may need to leave the transfer tape on even longer. To speed up the process when it’s cold out, you can warm the application surface using a blow dryer on low heat.

Now that you know the tricks the experts use for applying decal, you should be able to get it right every time! But just in case you want even more information, you can find step by step instructions and more tips at Decal Installation Guides.

No Comments

Post A Comment

Successfully! Oops!

close

Select options

close